Mounting And Dismounting Bits; How To Use The Router - Hitachi M 12V Manual De Instrucciones

MOUNTING AND DISMOUNTING BITS

WARNING:
1. Mounting Bits:
Lock plate
Tighten
Fig. 3
2. Dismounting Bits:
When dismounting the bits, do so by following the steps for mounting bits in reverse order.

HOW TO USE THE ROUTER

1. Setting the cutting depth:
Knob
Wing bolt (B)
Wing bolt (A)
Cut depth setting screw
Stopper block
Stopper pole
Fig. 4
Loosen the
lock lever
Fig. 5
Be sure to switch power OFF and disconnect the plug from the receptacle
to avoid serious trouble.
(1) Insert the bit deeply in the collet chuck hole. As shown
in Fig. 3, press the lock plate, tighten the collet nut and
then use the accessory wrench to firmly tighten the
Wrench
collet chuck.
Loosen
Ensure that the collet chuck is firmly tightened after
inserting a bit. Failure to do so will result in damage
to the collet chuck.
Model M12V(S), M12SA(S)
Be sure to use a chuck sleeve when using bits of 1/4"
(6.35mm) or 3/8" (9.5mm). First insert the chuck sleeve
deeply in the collet chuck, then insert the bit in the chuck
sleeve. Tighten the collet chuck firmly as in step (1).
CAUTION
(1) As shown in Fig. 4, turn the stopper block so that
the section to which the cut depth setting screw
on stopper block is not attached comes to the
bottom of the stopper pole. Loosen wing bolt (A)
and turn knob to bring stopper pole in contact
with stopper block.
(2) As shown in Fig. 5, loosen the lock lever and
press down the main unit until the bit comes into
slight contact with the surface of the materials.
Tighten the lock lever at this point.
English
15