Quick starter guide
To start your night vision monocular, proceed as follow:
Press the power button (A) to turn on the unit.
The NUM'AXES logo will appear on the display.
While looking through the eyepiece (M) at the LCD display screen, rotate the eyepiece until the display icons or edges of the display screen appear sharp to your eye.
Remove the lens cover from the front of the objective lens (L).
If the image is not sharp, rotate the objective lens barrel (L) to change the focus until the subject appears sharp.
The NUM'AXES monocular, VIS1012, uses digital night vision technology. The unit cannot be damaged by exposure to normal indoor or outdoor light levels. However you should avoid
pointing it directly at the sun or other very bright light sources to avoid overloading the sensor.
Turn on IR light if needed. If the image is too dark to easily view, press the IR button (C) to turn on the infrared LED light. If the image is too bright after turning on the IR light, press
the IR button again to reduce the IR light level.
If the image is still too dark after turning on the IR light, try pressing the image brightness button (E) once or twice to lower frame rate of the digital sensor.
Presentation of the setup menu interface
Press brightness switch (E) and held for 2 seconds to enter into the setup menu interface. The setup menu includes the following options :
Choice of the language
Choice of the resolution
Choice of movie size
Date and time set up
Backlight brightness set up
USB
Buttons functions in the setup interface
In the setup interface, the buttons of your digital night vision unit are given the following functions:
Image brightness button
-
Enter/Exit the main setup menu interface: Press and hold on for 3 seconds to enter/Exit setup interface.
-
Used too as a confirm button when you are in back light setting interface.
, enables you:
24/65