BH FITNESS G2351i Instrucciones De Montaje página 18

doing exercise) refit the knobs (90),
the washers (89) (91) and the screws
(48) removed previously and tighten
securely.
Next, position the left footrest (47L)
(marked with the letter "L") on top of
the left foot (45), refit the knobs (90),
the washers (89) (91) and the screws
(48) removed previously and tighten
securely.
11. FITTING MONITOR.-
ATTACHING THE FEEDBACK CABLE
Take hold of the cable (19), which is
sticking up out of the main post (21),
and plug it into the connector of the
electronic unit (1), as shown in Fig.13.
FITTING THE HAND-GRIP CABLE.
Take hold of the Hand-grip connectors
(2), sticking out of the main post (21),
and plug them into the connectors
located at the back of the monitor (1),
as shown in Fig.13.
ATTACHING THE MONITOR.-
Release screws (20), Fig.13, at the
back of the monitor.
Next, slide the front of the monitor
onto the plate on top of the main post
(21) in the direction of the arrow,
Fig.14, push the cables down into the
main post making sure not the pinch
any of the cables. Replace the screws
(20) removed previously.
ATTENTION:
It is important to retighten all of the
screws involved in assembling the
machine after approximately a week of
use as this will prevent any strange
noises and possible damage.
12. FITTING THE HANDLEBAR.-
Take the handlebar (112), remove
screws (14), position the ends of the
handlebar on the plate at the top of
the main post (21), Fig.14. Refit the
screws (14) removed previously.
FITTING THE HAND-GRIP CABLE.
Take the covers (18B) (18F) (8R) (8L)
and position them on the main post
(80), Fig.14.
Now use the screws (110) (16) to
attach them to the post.
MAINS CONNECTION.-
Insert the jack (m) on the transformer
(116) into the connection hole (k) on
the main body (101) (bottom, rear of
the machine) and then plug the
transformer into a 220 V mains supply,
Fig.17.
LEVELLING.-
Once the unit has been placed into its
final position, make sure that it sits flat
on the floor and that it is level. This
can be achieved by screwing the
adjustable feet (69) up or down, as
shown in Fig.15.
MOVEMENT & STORAGE.-
The unit is equipped with wheels (104)
to make it easier to move. The wheels
located at the front of your unit make it
easier to move it into a chosen
position, by lifting the rear of the unit
up slightly and pushing it, as shown in
Fig.16. Store your unit in a dry place,
preferably not subject to changes in
temperature.
18