Machine Guidance Methods - Festool OF 2200 EB Manual De Instrucciones

Always advance the router in the
same direction as the cutting direction of the cut-
ter (counter-routing)!
You should wear a dust mask for work
which produces dust.
Procedure:
– Preset the required routing depth.
– Switch on the machine.
– Unscrew the rotary knob [13.1].
– Push the machine down as far as possible.
– Clamp the machine in this position by tightening
the rotary knob [13.1].
– Perform the routing task.
– Unscrew the rotary knob [13.1].
– Move the machine slowly upwards to the stop.
– Switch off the machine.

Machine guidance methods

a) Routing with side stop
The side stop (partly as an accessory) is positioned
parallel to the workpiece edge.
15.1
– Secure both guide rods [15.4] with the two rotary
knobs [15.2] on the side stop.
– Insert the guide rods into the grooves on the
router base to the required distance and secure
them by turning the rotary knob [15.1].
Fine adjustment
– Unscrew the rotary knob [15.7] to make fi ne
adjustments with the adjusting wheel [15.5].
The dial ring [15.6] has a 0.1 mm scale for this
purpose. If the adjusting wheel is held secure,
the dial ring can be turned separately and set
to "Zero". The millimetre scale [15.3] on the
15.2 15.3
main casing is useful for making larger adjust-
ments.
– Tighten the rotary knob [15.7] again after com-
pleting any fi ne adjustments.
16.1
16.2
16.3
– Adjust both guidance jaws [16.3] so that they are
approx. 5 mm from the router bit. To do this, undo
screws [16.2] and tighten again after completing
the adjustments.
– Only when routing along an edge: slide the ex-
tractor hood [16.1] until it latches into position
on the side stop and connect an extraction hose
27 mm or 36 mm in diameter to the extractor
connector [16.4]. Alternatively, leave the machine
to extract the dust via the extractor connector.
b) Copy routing
When routing with templates, fi t an integrated copy-
ing ring to the router (accessory).
Note:
 Copying rings can be used in combination with
the standard base runner. A special base run-
ner is available as an accessory to improve the
contact surface.
may damage the copying ring and cause accidents.
15.7
Make sure that the routing tool used fi ts through
the opening on the copying ring.
15.6
15.5
Procedure:
17.1
15.4
17.2
17.3
17.4
– Lay the machine on its side on a stable base.
– Open the lever [17.4].
– Remove the base runner [17.1].
An excessively large routing tool
13
16.4