Makita RT0700C Manual De Instrucciones página 14

Recortadora
Ocultar thumbs Ver también para RT0700C:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

NOTE:
The workpiece will be cut a slightly different
size from the templet. Allow for the distance (X)
between the bit and the outside of the templet
guide. The distance (X) can be calculated by
using the following equation:
Distance (X) = (outside diameter of the templet guide -
bit diameter) / 2
Dust nozzle sets (optional
accessory)
For the trimmer base
1
► 1. Dust nozzle 2. Thumb screw 3. Trimmer base
For the plunge base
1
► 1. Dust nozzle 2. Thumb screw
Use the dust nozzle for dust extraction. Install the dust
nozzle on the tool base using the thumb screw so that
protrusion on the dust nozzle fit to the notch in the tool
base.
Then connect a vacuum cleaner to the dust nozzle.
3
2
2
MAINTENANCE
CAUTION:
Always be sure that the tool is switched off and
unplugged before attempting to perform inspec-
tion or maintenance.
Never use gasoline, benzine, thinner, alcohol
or the like. Discoloration, deformation or cracks
may result.
Replacing carbon brushes
► 1. Limit mark
Remove and check the carbon brushes regularly.
Replace when they wear down to the limit mark. Keep
the carbon brushes clean and free to slip in the holders.
Both carbon brushes should be replaced at the same
time. Use only identical carbon brushes.
Use a screwdriver to remove the brush holder caps.
Take out the worn carbon brushes, insert the new ones
and secure the brush holder caps.
14 ENGLISH
1

Hide quick links:

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Rt0701c

Tabla de contenido