Craftsman professional INCREDI-PULL 316.794000 Manual Del Operador página 5

ASSEMBLING THE BLOWER TUBE
iA iw.°...O; oavoi ,e,iou e,sona,,n,u n I
shut the unit off before removing or installing the blower tubes.
Installing the Flex Tube
1. Place a hose clamp over the end
of the flex tube (Fig. 1).
2. Slide the end of the flex tube with
the clamp on it over the elbow
tube and tighten the screw on the
hose clamp (Fig. 1).
Installing the Upper Blower Tube
1. Place a hose clamp over the
other end of the flex tube (Fig. 2).
2. Slide the end of the hose with the
clamp on it over the top end of
the upper blower tube and
tighten the screw on the hose
clamp (Fig. 2).
Installing the Lower Blower Tube and
Nozzle
1. Insert the bump on the upper
blower tube into the bump slot
on the lower blower tube (Fig. 3).
2. While holding the upper blower
tube, twist the lower blower tube
clockwise until it locks into place
(Fig. 3).
3. Insert the bump on the lower
blower tube into the bump slot
on the nozzle (Fig. 4).
4. While holding the lower blower
tube, twist the nozzle clockwise
until it locks into place (Fig. 4).
The completed blower tube should
look like Figure 7.
Fig, 1
Flex (_
L
ower Tube _
Fig, 2
_/, Upper
Blower Tube
Blower Tube
Fig, 3
Lower
I1_ BI .... Tube
_ Nozzle
Fig, 4
tubes are locked in place or firmly installed.
Secure the Throttle Cables
Place a zip tie around the elbow tube
and the throttle cables, as shown (Fig. 5).
Tighten the zip tie, making sure not to
crimp the cables.
Cables _/_...--_ Elbow
Zip Tie
Fig, 5
Adjusting the Throttle Grip
1. Move the throttle grip to a location
on the upper blower tube that
provides the best grip (Fig. 6).
2. Using a T-20 Torx ®screwdriver,
tighten the two screws at the
bottom of the throttle grip (Fig. 6).
Throttle Cables
Upper Blower Tube.
Throttle Grip
Lower
Blower Tube
Nozzle
Upper
Blower
Tube
-i
Throttle
Grip
T-20 Torx ®Screw
Fig, 6
Flex Tube
On/Off Switch
Fig, 7