Glacier bay HDQFS1A9277CP Guía De Instalación Y Cuidado página 4

Installation
Installation
1
Installing the faucet assembly
WARNING: Always turn off the water supply before
removing an existing faucet or replacing any part of a
faucet. Open the faucet handle to relieve water pressure
and ensure that the water is completely shut off.
□
Shut off the water supply. Remove the old faucet.
□
Clean off the mounting surface.
□
Remove the lock nut (F).
□
WITHOUT THE DECK PLATE: Insert the supply lines
(I) through the spout trim ring (C) and mounting
hole in the sink until the faucet (A) sets on top of
the sink, ensuring the tab on the spout trim ring
(C) is aligned with the hole at the bottom left of
the faucet (A).
□
WITH THE DECK PLATE: Align the hole in the Putty
plate (H) and deck plate (G) with the mounting
hole in the sink. Insert the supply lines (I) through
the spout trim ring (C) , deck plate (G) and
mounting hole in the sink until the faucet (A) sets
on top of the deck plate (G), ensuring the tab on
the spout trim ring (C) is aligned with the hole at
the bottom left of the faucet (A).
G
H
1
NOTE: If the sink is uneven, use silicone under the Putty
plate (H).
A
C
F
I
A
C
I
2
2
Securing the faucet
□
Slide the rubber washer (D) and metal washer (E)
over threaded rods (K). Use the lock nuts (F) to
secure the rubber washer (D) and metal washer
(E).
NOTE: Make sure the faucet (A), spout trim ring (C) and
the deck plate (G) are aligned while tightening the lock
nut (F).
4
K
D
E
F