Publicidad
Idiomas disponibles
Idiomas disponibles
accessories for this unit are available at the store the unit was purchased.
The use of any other accessory not recommended for use with
this tool could be hazardous. Use only accessories rated equal to or higher
than the rating of the air compressor.
TOOLS REqUIRED FOR ASSEMBLY
1 - 9/16" socket or open end wrench
1 - 3/8" socket or open end wrench
1 - 1/2" socket or open end wrench
UNPACkING
Remove unit from carton and dis-
card all packaging. NOTE: Save all
parts bags.
ASSEMBLE HANDLE
1.
To make installation easier,
submerge handle grip into
warm soapy water.
handle grip from soapy water
and slide onto handle.
2.
Insert the handle inside the
compressor saddle and line up
the two bolt holes on each
side.
3.
Install the four screws, two on
each side.
4.
Tighten securely.
ASSEMBLE WHEELS
It will be necessary to brace or support one side of the outfit when
installing the wheels because the compressor will have a tendency to tip.
attach wheels with shoulder bolts and nuts as shown. NOTE: Place the bolts
1.
in the bottom hole of the wheel bracket.
Tighten securely. NOTE: The outfit will sit level if the wheels are properly
2.
installed.
The wheels and handle do not provide adequate clearance, stabil-
ity or support for pulling the unit up and down stairs or steps. The unit must be
lifted, or pushed up a ramp.
ASSEMBLE RUBBER FEET
1.
attach rubber feet with the screws provided as shown in previous figure.
2.
Tighten securely.
ACCESSORIES
ASSEMBLY
Handle Grip
Remove
9 - eNG
Screw
Handle
Nut
Wheel
Shoulder Bolt
Rubber Feet
Screw
Publicidad
