Publicidad
Idiomas disponibles
Idiomas disponibles
Automatic Icemaker & Ice/Water
Dispenser
(continued}
Once Your Icemaker & Dispenserare in Operation
Throw away the firstfew batches of ice cubes ( 16 or 24 cubes)
Thiswil! flush away any impurities in the water line. Do the same
thing a[ler vacations or extended periods when ice isn't used
To clean out the line, pour the first six glassfuls of water in the
kitchen sink The first water through the system picks up a
slight "plastic" taste from the water tubing,
To make sure the bin fills with ice, level the cubes
occasionally.
When cubes fall into the bin they may pile up
close to the icemaker and push the feeler arm to the STOP(up)
position before the bin gets full, Keeping the cubes level
allows the icemaker to fill the bin_
To Dispense Ice and Water
• Select CUBES,CRUSHED ICE (on some models) or WATER.
o Grip lhe glass or other container near the rim and press
the rim against the center of the dispenser pad.
When Dispensing
Ice:
• Some crushed ice may be
dispensed even though you
selected CUBES. This happens
occasionally when a few cubes
get channeled to the crusher..
o Sometimes a mound of snow will
form on the door in the ice chute
This condition is normal, and usually occurs when you
have dispensed crushed ice repeatedly. The snow will
eventually evaporate.
o Sometimes crushed ice will spray beyond the glass.
To avoid this, hold the glass up close to the chute,
When Dispensing Water:
o The first glass of water dispensed
may be warmer than the following
ones. This is normal.
• Dispensed water is cool, not iced.
For colder water, simply add
crushed ice or cubes before
dispensing water.
CAUTION: Never put fingers or other
objects into the dispenser opening.
To Stop Dispensing
Release pressure Fromthe dispenser
pad and wait a few seconds to catch
the last bits of ice or drops of water,
There may be some dripping after
dispensing of crushed ice or water, If
there is a lot of dripping, the spill
should be wiped dry right away.. Do not pour water in the
spill shelf because it is not self draining-pour
it in the kitchen
sink, The shelf and its grille should be cleaned regularly
according to Care and Cleaning instructions..
The grille is easily removed by
pressing on the back right corner
Press here to -3
remove grille
if Ice Clumps Form in the Storage Bin,,.
The icemaker ejects cubes in groups of eight, and it is
normal for several cubes to be joined together, However, if
you don't use the ice very often ice clumps may form in the
storage bin and can clog the dispenser., If this happens:
o Remove the storage bin from the freezer.
o Break up ice clumps with your hands.,Throw away any
clumps that you can't break up,,
• Replace the bin before the remaining cubes melt and fuse
together.
To Remove Ice Storage Bin
Lift the left corner to free the bin from
the shelf, Pull the bin straight out while
supporting it at front and back.
To Replace Ice Storage Bin
Slide the bin back until the tab on the
bin locks into the slot in the shelf
If the bin does not go all the way
back, remove it and turn the drive
mechanism I/4
turn° Then push the
bin back again until the tab on the
bin locks into the slot in the shelf.
Drive
Mechanism
If Ice Is Not Used Often...
"Old"
ice cubes will become cloudy and taste state, Empty
ice storage bin periodically and wash it in lukewarm water.
Be sure to allow storage bin to coot before replacing it-
otherwise ice cubes will stick to the metal auger.
Move Feeler Arm to STOP (up) Position when,o,
• Home water supply is to be turned off for several hours
° Ice storage bin is to be removed for a period of time.
° Going. away on vacation, at which time you should also
turn o!t the valve in the water supply line to your refrigerator..
o Moving the Fresh Food control to the OFF position.
Publicidad
