Publicidad
Idiomas disponibles
Idiomas disponibles
EN
2.- ASSEMBLY OF THE HEATER
Before using the heater, the feet (supplied separately in the carton), must be fitted to the unit. These are
to be attached to the base of the heater using the 4 self-tapping screws provided, taking care to ensure
that they are located correctly in the bottom ends of the heater side moldings.
3.- USING THE HEATER
Choose a suitable location for the heater, taking into account the safety
instructions above.
Insert the plug of the heater into a suitable socket (230V/50Hz).
Turn the thermostat knob fully in a clockwise direction to the maximum setting.
Turn on the power by means of the thermostat switch on the side panel. When
the power is on, the power indicator will light up. Then turn on the heating
function by means of the function selector switch "I" on the side panel. For
maximum heat output the selector switch should be turned to the most high-
grade "II". When the desired room temperature has been reached, the
thermostat knob should be turned slowly anti-clockwise until the thermostat is
heard to click off and the lights on the element switches are seen to go out.
After this the heater will keep the air temperature in the room at the set
temperature by switching on and off automatically.
Convector heater with fan (Turbo for fast-heating)
When the selector switch is turned to the low-speed
position, there is an air outlet on the side panel, the heating low-
grade also turn on the fan. For maximum heat output the selector switch should be turned to the most high-speed
the
heating high-speed also turn on the fan.
Convector heater with Timer
This model is also fitted with a 24hr timer which has 96 segments
around its circumference, each segment being equivalent to 15
minutes of time. With the aid of this timer it is possible to preset
the time and duration of the period(s) that it is desired the heater
will operate, in any 24hr period.
Timer Operation
The centre of the timer has a 3-position slide switch.
In the central position (denoted by the clock symbol) the timer will
switch the heater on and off at times set by the segments, (see
setting the timer, below).
The position denoted by the "I", is a timer override position. The
timer will continue to run but power will be fed continuously to
the heater. This enables the heater to be on all the time if
required.
In the position denoted by the "O", the timer continues to run but no power is fed to the heater.
7
Publicidad
