Sunny Health & Fitness SF-E905 Manual Del Usuario página 18

ADJUSTMENTS & USAGE GUIDE
1. If you find there is no difference between tension level 1 to level 8, please check the
connection of the tension cable. Please see Diagram A under STEP 2.
2. If the meter does not show numbers correctly, please check the batteries. If the meter
does not count the speed and time, please check the connections of Upper Sensor
Wire (No. 15) to the Meter Wire C (No. 38c) and Upper Sensor Wire (No. 15) to
Lower Sensor Wire (No. 16).
3. If you have difficulty putting Hinge Bolts (No. 49L/R) into the Crank Arm (No. 52), or
putting Hex Bolts (No. 21) into Pedal Support Tubes (No. 18L/R), please try moving
the Crank Arm (No. 52) to a different angle. *Keep in mind the Left Hinge Bolt (No.
49L) has reversed threading and must be installed by turning counter-clockwise.
4. If you hear any noise when using the machine, please check if Hinge Bolts (No.
49L/R), Hex Bolts (No. 21), Flat Washers (No. 26) and Connecting Joints (No. 19)
are loose. You may remove these parts and add some lubricant oil to eliminate all noise
possibilities. Remember to tighten all the parts securely.
5. When you first use the machine, if you hear any unusual noises from the inside of the
Belt Covers (No. 65L/R), please loosen the Bolts (No. 97) about two rotations, then
push the Belt Covers (No. 65L/R) up a little bit. Finally, fasten the Bolts (No. 97). See
the following diagram. [During shipping, the Belt Covers (No. 65L/R) can be dislocated,
and the Flywheel (No. 94) may rub on the Belt Covers (No. 65L/R).]
17