Craftsman 917.377190 Manual Del Propietário página 14

_LCAUTION: Before performing any
service and adjustments:
• Release control bar and stop engine.
• Make sure the blade and all moving
parts have completely stopped.
• Disconnect spark plug wire from spark
plug and place where it cannot come
in contact with plug.
LAWN MOWER
TO ADJUST CUTTING HEIGHT
See "TO ADJUST CUNING HEIGHT" in the
Operation seclJon of this manual.
REAR DEFLECTOR
The rear deflector, attached betweenthe rear
wheels of your lawn mower,is providedto
minimize the possibility that objectswillbe
thrownout the rear of the lawn mowerintothe
operator's mowing position. If the rear
deflectorbecomes damaged, it should be
replaced.
TO REMOVE/REPLACE DRIVE BELT
• Remove drive cover. Remove belt by
pushing down on gear case pulley and roll
beit off.
•Tum lawn mower on its side with carbure-
tor and fuel cap up.
• Remove blade.
• Remove debris shield.
• Remove belt from engine pulley on
crankshaft.
• Install new belt by reversing above steps.
• Always use factory approvedbelt to assure
fit and long life.
Belt _[_ _!
Push ImH
down I- Inl/! iii=
TO ADJUST HANDLE
The handle can be mounted in a high or
low position. The mounting holes in the
bottom of lower handle are off center for
raising or lowering the handle.
• Remove upper handle and all parts
attached to lower handle.
• Remove hairpin cotters from lower
handle bracket mounting pin.
• Squeeze lower handle in to remove it
from mounting pins.
• Turn lower handle over to raise or lower
handle.
• Squeeze lower handle in and position
holes onto mounting pins on handle
bracket.
• Reassemble upper handle and all parts
removed from lower handle.
Mowing ., Mowing .
position ,_._ position / i'
, !
• a
Low position High position
¥
Rotate
Lower
handle
14