Publicidad
Idiomas disponibles
Idiomas disponibles
ENGINEOIL
Drain oil (with engine warm) and replace with
clean engine oil. (See "ENGINE" in the
Maintenance
section of this manual).
CYLINDER
• Remove spark plug.
• Pour one ounce (29 rnl) of oil through spark
plug hole into cylinder.
• Pull starter handle slowly a few fimas to
distribute oil.
• Replace with new spark plug.
OTHER
• Do not store gasoline from one season to
another.
TROUBLESHOOTING
CHART
PROBLEM
CAUSE
Does not start
1.
Dirty air filter.
2.
Out offuel.
3.
Stale fuel.
4.
Water in fuel.
.
6.
7.
8.
g.
Loss of power
1.
2.
3.
4.
5.
6.
Poor cut-
uneven
1.
2.
3.
Spark plug wire is
disconnected.
Bad spark plug.
Loose blade or broken blade
adapter.
Control bar in released
position.
Control bar defective.
Rear of lawn mower housing
or cutting blade dragging
in heavy grass.
Cutting too much grass.
Dirty air filter.
Buildup of grass, leaves,
and trash under mower.
Ton much oil in engine.
Walking speed too fast.
Wom, bent or loose blade.
Wheel heights uneven.
Buildup of grass, leaves
and trash under mower.
• Replace your gasoline can if your can
starts to rusL Rust and/or dirt in your
gasoline will cause problems.
• If possible, store your unit indoors and
cover it to give protection from dust and dirt.
• Cover your unit with a suitable protective
cover that does not retain moisture.
Do
not use plastic. Plastic cannot breathe
which allows condensation
to form and will
cause your unit to rust.
IMPORTANT:
Never cover mower while
engine
and exhaust areas are still warm.
_,CAUTION:
Never store the lawn
mower
with gasoline
in the tank inside a
building
where
fumes
may reach an open
flame or spark.
Allow the engine to cool
before
storing
in any enclosure.
CORRECTION
1.
Clean/replace air filter.
2.
Fill fuel tank.
3.
Drain tank and refill with
fresh clean fuel.
4.
Drain fuel tank and
carburetor and refill tank
with fresh gasoline.
5.
Connect wire to plug.
6.
7.
8.
9.
1.
Replace spark plug.
]3ghten blade holt or
replace blade adapter.
Depress controlbar to
handle.
Replace controlbar.
Set to "Higher Cut"
position.
2.
Set to "Higher Cut"
position.
3.
Clean/replace
air filter.
4.
Clean underside of mower
housing.
5.
Check oil level.
6.
Cut at slower walking
speed.
1.
Replace blade. "13ghten
blade holt.
2.
Set all wheals at same
height
3.
Clean underside of
mower housing.
17
Publicidad
