Kenmore 116.30012 Manual Del Propietário página 6

CAUTION
Do not overtighten°
Overtightening could strip the screw
holes,
Do not operate the cleaner without
the screw in place,
Using a screwdriv-
er, tighten the
screw_
i
CORD ASSEMBLY
Make sure the quick release cord hook is in
the upright position, Remove the wire tie
from the power cord,
Lock the cord into _,
place by forcing it
into the locking
notch on the body
of the quick Notch
release cord hook (,\\
as shown This
helps keep the
power cord out
from under the
rd
_t
vacuum cleaner /
agitator_
Quick Release
Cord Hook..._
Power
Lower Cord
Wrap the
power cord
around the
quick release
cord hook
and lower
cord retainer,
then lock the
power cord
plug onto the
power cord,
ATTACHMENT ASSEMBLY
After the handle has been assembled to the
body and the power cord has been wrapped
around the cord hooks, the attachments can
be assembled,
1. Snap the suction inlet end of the hose
into the back of the vacuum cleaner
2. Place the hose behind the handle and
over the hose holder
3. Attach the wand with tabs to the hose by
aligning the two (2) raised tabs on the wand
with the "J" slots in the hose.
4, Place the wand in the front slot of the
tool holder, twisting and pushing down over
the short hose to assure a good connection_
5. Place the other wand in the rear slot of
the tool holder.
6. Slide the crevice tool into the slot beside
the wand,
7. Place the dusting brush or comination
brush on the wand with the brush portion
up
Handle
Hose
Wand
(With Tabs)
Suction
Inlet
-- Wand
Crevice
Tool
Tool
Holder
Sho_ Hose