Publicidad
Idiomas disponibles
Idiomas disponibles
Before Using This Unit
Thank you for purchasing the Onkyo
CP-1055F
Direct Drive Fully
Automatic
Turntable.
This fine
instrument has been carefully designed and
constructed to provide years of enjoyment.
To be
sure you receive optimum performance from this
unit, please read this instruction manual
carefully
before installing and using the CP-1055F
and keep
the
manual
for future reference.
Locating the unit:
Because the CP-1055F
is a precision made instrument,
it is very sensitive to vibrations,
temperature
changes,
humidity, dust, and other environmental
factors.
To
assure that you enjoy all the benefits of this fine
turntable, observe the following points when
selecting
its location:
To prevent howling, avoid places subject to vibrations,
particularly those from the speakers.
Also, be sure
the dust cover and body are not touching the audio
rack or any other object.
Select a sturdy, level spot; even a slight inclination
may significantly affect tracing accuracy.
Avoid
places exposed to direct sunlight, heat producing
appliances, dust, and high humidity.
Always close the dust cover when the unit is not being
used.
Care and Maintenance
1. Clean the stylus periodically with a soft brush to
prevent the accumulation of dust.
From
time to time, the dust cover and turntable
cabinet should be wiped with a soft, dry cloth.
Furniture wax, insecticides, volatile compounds,
and
chemical cloths can damage the surface.
. When
the unit is shipped again, remove the counter-
weight and turntable platter and fix the tonearm to
the
rest with the hook and adhesive tape.
2
Power Supply Voltages
Before connecting the unit to an AC outlet, check
whether it is set for the local AC voitage.
The turntable
may be set to operate at either 110, 120, 220 or 240 V.
The voltage selector is under the turntable platter.
If a voltage change is necessary, switch to the proper
voltage.
Note that the CP-1055F operates at both 50 and
60 Hz power frequencies.
Note:
Some units have been designed to operate only
on AC 240 V 50 Hz or AC 220 V 50 Hz or 120 V
50/60 Hz
and are consequently not equipped
with a voltage selector.
Turntable Parts and Controls
Shown
below is the turntable before assembly.
Be
sure to assemble and adjust the turntable and tonearm —
following the order described in this manual.
Do not
plug in the power cord until all the steps have been
completed and double checked.
:
turntable
mat
U1
[2]
center spindle
[3]
turntable platter
[4]
power cord
remote control jack
[6]
output cords
[7}
dust cover holders
counterweight
[9]
scale ring
anti-skating knob
11}
arm rest hook
(12)
arm rest
13)
tonearm
14
headshell connection screw
15|
headshell (cartridge)
16
play/reject button
17}
cue button
( ¥/¥)
18
search button
191
repeat button
201
stroboscope
21)
record size selector
22}
speed selector
power button
Installing the Turntable Platter
Fit the turntable platter over the center spindle, holding
firmly with both hands to be sure it is level.
23) [22] 21) 20
Publicidad
