Kenmore 78073 Manual Del Propietário página 8

_1_ The vent control handle must be straightened
before the decorative front is attached. Pull down
part @ to align with part ®.
Part®
Part®
Vent Control Installation
Installing Bottom Rail Seal
I
FIG. 18
_1 FRONT INSTALLATION
• Hook upper tabs of front grille into slots on the
cabinet top.(FIG. 19)
• Push front grille towards the cabinet in order to
snap side tabs into the cabinet.(FIG. 19)
• Open the filter door.(FIG. 20)
• Tighten the TYPE A screw (_ through the front
grille.(FIG. 20)
• Close filter door.(FIG. 21)
Front Installation
@
FIG. 19
IF AIR CONDITIONER IS BLOCKED BY STORM
WINDOW FRAME
Add wood to clear frame as shown in FIG. 22, or
remove storm window frame while air conditioner is
installed.
Sash
Wn t_-v'l hlnc.k 1 1/2"min
I areV - -a-of -- (38mm)
leveling n'_L_-
support _11_ _ " J 1
I _ J Boa.rd thickness as
] _ required, along
Storm w_lndowframe entire stool
or other obstruction Fasten with two
nails or screws.
FIG. 22
AIR CONDITIONER REMOVAL
Turn the air conditioner off, disconnect the power
cord, remove the window locking bracket and the
screws installed through the top and bottom of the
side curtains. Save all parts for later reinstallation.
Close the side curtains. Keeping a firm grip on the
air conditioner, raise the sash, and carefully tilt the
air conditioner backward, draining any condensed
water. Lift the air conditioner from the window.
Remove the sash seal from between the windows.
Front Installation
FIG. 20
Front Installation
FIG. 21
• Air conditioners covered in this manual pose an
excessive weight hazard. Two or more people
are needed to move and install the unit.
To prevent injury or strain, use proper lifting and
carrying techniques when moving unit.
• When handling the air conditioner, be careful to
avoid cuts from sharp metal fins on front and
rear coils.
• Make sure air conditioner does not fall dudng
removal.