Wall Mounting; Anti-Freeze Protection - S&P TLS-501 Instrucciones De Uso

WALL MOUNTING

Wall mounting is only possible when the base supports are not fitted. Once you
have chosen the location, before fixing the convector to the wall, make sure that
the minimum distances are respected (Fig. 3A).
Proceed to mark and fix the two upper supports with the plugs and screws. Once
the apparatus hanging thereof by immobilizing the lower support (Fig.3B).
SWITCHING ON AND OPERATION
Once you have checked that the mains voltage coincides with the voltage
indicated on the name plate, connect the convector.
1.- Select the power using the power selector command and turn the thermostat
command in the direction of clockwise to its maximum position (Fig.4).
2.- Once the room has reached the desired temperature, turn the thermostat
control anticlockwise until you hear a slight click. When the thermostat control is
in this position, the convector will connect and disconnect automatically to keep
the pre-selected temperature constant.
COMBINED OPERATION (Only TLS-503T model)
To accelerate the heating of the room you can also connect the fan by pressing
the fan switch. In this position the switch will light up.

ANTI-FREEZE PROTECTION

The S&P convectors incorporate an anti-freeze device which triggers the
convector when the room temperature drops below +5ºC.
To activate this device just connect the convector to the mains, place the power
selector in any of the active positions and the thermostat control in the
position (Fig.4).
0 OFF
I Low power
II Medium power
III High power