Publicidad
Idiomas disponibles
Idiomas disponibles
MAINTENANCE
General
Hatco Intelligent Toast-Qwik
for maximum durability and performance with minimum
maintenance.
WARNING
ELECTRIC SHOCK HAZARD:
• Put unit in standby, allow to cool, turn OFF power
switch, and unplug power cord before performing
cleaning, adjustments, maintenance, or attempting to
clear a jam.
• DO NOT submerge or saturate with water. Unit is not
waterproof. Do not operate if unit has been submerged
or saturated with water.
• Do not steam clean or use excessive water on unit.
• This unit is not "jet-proof" construction. Do not use jet-
clean spray to clean this unit.
• Do not clean unit when it is energized or hot.
• Do not allow liquids to spill into unit.
• This unit must be serviced by qualified personnel only.
Service by unqualified personnel may lead to electric
shock or burn.
• Use only Genuine Hatco Replacement Parts when
service is required. Failure to use Genuine Hatco
Replacement Parts will void all warranties and may
subject operators of the equipment to hazardous
electrical voltage, resulting in electrical shock or burn.
Genuine Hatco Replacement Parts are specified to
operate safely in the environments in which they are
used. Some aftermarket or generic replacement parts
do not have the characteristics that will allow them to
operate safely in Hatco equipment.
This unit has no "user-serviceable" parts. If service
is required on this unit, contact an Authorized Hatco
Service Agent or contact the Hatco Service Department at
414-671-6350.
Daily Cleaning
To preserve the finish of the toaster, it is recommended that the
metal surfaces be cleaned daily.
WARNING
Submerging or saturating unit with water will damage the
unit and void unit warranty.
NOTICE
Use non-abrasive cleaners and cloths only. Abrasive clean-
ers and cloths could scratch finish of unit, marring its ap-
pearance and making it susceptible to soil accumulation.
Clean unit daily to avoid malfunctions and maintain sani-
tary operation.
Conveyor Toasters are designed
®
1. Perform the "Daily Shutdown" procedure in the
OPERATION section, and unplug the power cord.
BURN HAZARD: Do not remove crumb trays, toast chute,
or toast chute slide for cleaning until toaster is cool.
2. Remove and empty the crumb tray(s), toast chute slide
(ITQ-1750-2C), and the toast chute.
a. Wash the crumb tray(s), toast chute slide, and toast
chute with warm water and a mild detergent. Rinse with
water.
b. Allow the crumb tray(s), toast chute slide, and toast
chute to air dry.
3. Wipe the exterior surfaces of the toaster with a non-
abrasive, damp cloth.
• Stubborn stains may be removed with a good stainless
steel cleaner or a non-abrasive cleaner. Hard to reach
areas should be cleaned with a small brush and mild
soap.
4. Clean/polish the product sensor covers and sensor
reflectors using a mild degreaser and a soft, non-abrasive
cloth. NOTICE: Do not clean sensor covers or reflectors
with abrasive pads or cleaners.
NOTE: Sensor reflectors are present on dual conveyor units only.
Product Sensors and Sensor Reflectors (ITQ-1750-2C shown)
5. Reinstall the crumb tray(s) and toast chute. Refer to the
INSTALLATION section for details.
6. For ITQ-1750-2C models, install the toast chute slide onto
the toast chute.
12
CAUTION
Product Sensor
Covers
Sensor Reflectors
Form No. ITQCEM1-0717
Publicidad
