KNOVA KN ID-13A Manual Del Usuario página 5

OPERATION
WARNING
Observe correct main
voltage! The voltage of the power
source must agree with the voltage
specified on the nameplate of the
machine.
Auxiliary handle and Depth gauge
CAUTION
: Always ensure that
the drill is switched off and plug is
removed from the power point before
making any adjustments,
a. Turn the handle grip anti-clockwise
to loosen the collar and slip it over
the chuck onto the tool.
b. Adjust the position of the handle to
suit the application.The auxiliary
handle can be swiveled 360°
(See fig.2)
Fig. 2
c. The depth gauge helps keep an
accurate depth when drilling holes
to a set depth. Add the depth gauge
and tighten the handle to secure
them in place.(See fig.3)
Fig. 3
Trigger Switch
1) Discontinuously operation
ON: Depress the trigger switch
OFF: Release the trigger switch
2) Continuously operation
ON: Depress the trigger switch and
the lock on button
OFF: Release the trigger switch
Adjusting the Speed
This tool has a variable speed switch that
delivers higher speed and torque with
increased trigger pressure. Speed is
controlled by the amount of switch trigger
depression.Variable speed dial is used to
adjust the drilling speed, turn the dial to
the "F" direction to increase the speed and
to the "A" direction to decrease the speed.
NOTE
: Must turn off the drill when
adjust the drilling speed by the
variable speed dial.
Forward/Reverse control (See fig.4)
With the hammer drill placed toward the
operator
a. To select forward rotation, push the
forward/reverse control to right side.
b. To select reverse rotation, push the
forward/reverse control to left side.
c. The forward/reverse control cannot
be pushed left or right when the
trigger switch is depressed.
WARNING
: When changing the
position of the Fig.4 control, be sure
the trigger is released and the motor
is stationary.
NOTE
: The first
time the tool is run
after changing the
direction of rotation,
you may hear a click on
star up. This is normal
and does not indicate a problem.
Fig. 4