Domo DO91125 Manual De Instrucciones página 48

Idiomas disponibles

Make sure there is sufficient space to open the door.

This cooling unit is not intended for use as a built-in appliance.

Select a place with a strong, level floor.

Avoid direct sunlight and heat. Direct sunlight may affect the acrylic coating. Heat sources nearby will

cause higher electricity consumption.

Avoid very moist places. Too much moisture in the air will cause frost to form very quickly on the

evaporator, and your refrigerator.

Before connecting your refrigerator to the power supply, check that the voltage stated on the rating

label of your appliance corresponds to the voltage in your home. A different voltage could damage the

appliance.

After installation, leave the fridge for 24 hours before turning it on. This way the refrigerant can settle.

Allow the appliance to run empty for 8 hours so the compartment can cool to the appropriate

temperature.

One can level the appliance using the adjustable legs. The adjustable legs can be adjusted by screwing

them in or out of the appliance.

The climate class indicates the minimum and maximum ambient temperature for the proper operation

of an appliance. You can find the climate class on the type plate on the back of the appliance.

SN: Subnormal: ambient temperature between 10°C and 32°C

N: Normal: ambient temperature between 16°C and 32°C

ST: Subtropical: ambient temperature between 16°C and 38°C

T: Tropical: ambient temperature between 16°C and 43°C

DOOR CONVERSION

oor

If you need to hinge your door on the opposite side, it is recommended that you call your local authorised

service agent to make this conversion or ask a technician. Before you reverse the door, you should ensure

lips screwdriver, Flat bladed screwdriver, Hexagonal spanner.

the appliance is unplugged and empty. After reversing the door, leave the appliance alone for 8 hours

s unplugged and empty.

before switching it on. This allows the coolant to set.

off, it is necessary to tilt the unit backwards. You should rest the unit on something solid

slip during the door reversing process.

d must be saved to do the reinstallation of the door.

Remove the screws on the back of the top cover.

it flat as this may damage the coolant system.

2 people handle the unit during assembly.

ews at rear side of top cover.

DO91125

er and thermostat knob, then place it aside.

Lift

Lower

unscrew