StetSom Evolution Serie Manual De Usuario página 8

PRESENTATION OF CONTROLS
1
EVX TOP
• 2 CX-1 controls
ELT TOP
• 1 FLIP KEY EVO2 control
• 1 CX-1 control
1.1. INSTALLING THE "CODE" AND BLADE
3
Key blade not
included.
1
2
Illustrati on
A
To install the blade, remove the screws from Part
To install the "CODE" of your original key, follow these steps:
• With the fl ip key open, separate the parts
illustrati on ;
B
• Remove the screw and open Part
14
I-MOVE
• 1 CX-1 control
• 1 CX-1P control
ELT PLUS
• 1 FLIP KEY EVO2 control
• 1 CX-1P control
1 1
2
Illustrati on Illustrati on
B
as shown in illustrati on
3
and by moving it as shown in
1 2
, illustrati on .
1
C
• Place the "CODE" of your original key in the locati on
shown in illustrati on
• For larger "CODE" (Ex. FORD), place in the larger
space shown in illustrati on
silicone;
• To close, replace the cover Part
the positi on of the spring and turn 3 ti mes
counterclockwise to ensure proper opening pressure
for the blade;
• Screw Part
1
FUNCTION ON THE CONTROL AND RESPONSE OF THE ALARM
2
Press
Then
Then
Then
Screw
Then
For
3 segs.
Press
C
Twice (2x)
.
A
NOTE: When the alarm is acti vated, the LED will blink faster for 30 seconds, and then start
reading the sensors.
* Only if functi on 10 (fl ashes) and 11 (siren) is enabled (Item 18).
** Only if functi on 10 (fl ashes) is enabled.
;
D
. For this use glue or
E
observing
1
and a� ach Parts and .
1
2
Functi on
Blinkers fl ash once, siren beeps
Enable the alarm
once*
Blinkers fl ash twice, siren beeps
Disable the alarm
twice
Enable the alarm
Blinkers fl ash once**
without sound
Desati va o alarme
Blinkers fl ash twice**
sem sinal sonoro
Panic functi on
Sets off the alarm for 30 secs
Pulso negati vo no auxiliar, mantém
Auxiliary Functi on
saída negati va enquanto pressionado
Enable alarm wi-
Siren beeps twice
thout ultrasound
Localizati on
Blinkers fl ash for 15 secs
Functi on
CODE
Illustrati on
D
CODE
Illustrati on
E
Alarm Response
15