Publicidad
Idiomas disponibles
Idiomas disponibles
6. Before installing reverse (outside)
V-
belt, turn belt "inside out". Twist so
wide, flat surface of belt is to inside.
7. Wrap V-belt around reverse idler
pulley and reassemble idler to idler
arm. Tighten securely.
Be sure belt is
between reverse idler pulley and idler
arm pin.
8. Install belt to outside groove of
transmission pulley. Be sure belt is
inside all beltguides
and rests on
outside groove of engine pulley.
CHECK TINE OPERATION
9. See "TINE OPERATION
CHECK" in
this section of manual.
10. Replace belt guard.
FRONT
VIEW
REFERENCE
Reverse
Idler Pulley.
Idler Arm Pin
Engine Pulley
FORWARD
MOTION
(INSIDE)V-BELT
S_\
ine Pulley
Guide
Idler Pulley
Belt Guide
Idler
Pulley
TransmissionPulley
REVERSE
(OUTSIDE)
V-BELT
Reverse Idler Pulley
Reverse Idler Arm Reverse (OUTSIDE)
V-Belt
Reverse
Idler
Idler
Arm Pin
Pulley
Bel'
Forward
Guard
Bolt
Idler Pulley
Transmission
Pulley
ENGINE
Maintenance,
repair, or replacement
of
the emission
control devices and sys-
tems, which are being done at the
customers
expense,
may be performed
by any non-road engine repair establish-
ment or individual.
Warranty
repairs must
be performed
by an authorized
engine
manufacturer's
service outlet.
TO ADJUST
CARBURETOR
The carburetor has been preset at the
factory and adjustment
should not be
necessary.
However, engine perfor-
mance can be affected by differences
in
fuel, temperature,
altitude or load. If the
carburetor
does need adjustment,
contact
your nearest authorized
service center/
department
IMPORTANT:
Never tamper with the
engine governor,
which is factory set for
proper engine speed.
Overspeeding
the
engine above the factory high speed
setting can be dangerous.
If you think the
engine-governed
high speed
needs
adjusting, contact your nearest sears or
other qualified service center which has
the proper equipment
and experience
to
make any necessary
adjustments.
15
Publicidad
