Publicidad
Idiomas disponibles
Idiomas disponibles
•
Use recommended accessories (refer to page 15).
Use of improper accessories may cause risk of
injury to persons.
•
Handle workpiece correctly.Protect hands from
possible injury.
• Turn machine off if it jams. Blade jams when it digs
too deeply into workpiece. (Motor force keeps it
stuck in the work.)
• Always keep drive, cutterhead and blade guards in
place and in proper operating condition.
•
Feed work into blade or cutter against direction of
rotation.
CAUTION:
Think safety! Safety is a combinationof
operator common sense and alertness at all times
when tool is being used.
WARNING:
Do not attempt to operate tool untit it is
completely assembled according to the instructions.
Refer to Figure 1 below.
Check for shipping damage. If damage has occurred, a
claim must be filed with carrier. Check for complete-
ness. immediately report missing parts to dealer,
The planer comes assembled as one unit. Additional
parts which need to be fastened to planer should be
tocated and accounted for before assembling.
A. Planer
B. Handle Assembly
C. 6ram Flat Washer
D. 6-1.0 x 20mm Socket Pan Head Bolt
E. 6-1.0 x 25mm Socket Head Bolt
F. Pointer
G. Magnet (2)
H. 4ram HexWrench
I.
Dust Chute
J.
Half Bag Dust Collection Set (Not Shown)
Figure 1 - Unpacking
WARNING:
Do not attempt assembly if parts are
missing. Use this manual to order replacement parts,
INSTALL
HANDLE
Refer to Figures 2 and 3.
•
Handle with knob (A) can be installed either to
top-right or top-left side of the planer,
•
Remove plug on elevation screw (B) from the side
where handle will be installed.
Figure 2 - Install Handle
•
Insert handle with knob (A) onto elevation screw top
(B).
Figure 3 - Secure Handle
•
Positionthe pointer (E) and washer (D) on the handle.
• Secure handle with bolt (C) using the wrench
provided,
Publicidad
