Charging The Battery Bank - Wagan Tech iOnBoost V6 Manual De Usuario

CHARGING THE BATTERY BANK

This product may arrive partially charged from the manufacturer� It is recommended to
fully charge the unit immediately after purchase and before using for the first time� Prior to
charging the unit, read and understand all instructions in this manual�
In order to prolong the life of the battery bank, be sure to fully recharge the unit every 3 to 6
months, even if the battery bank has not been used.
WARNING
• Only use the charging adapters supplied with this unit!
• Do not charge the unit-on a boat, boat ramp, or dock since the electrical cords and outlets
used for charging could cause severe electrical shock if they get wet.
AC Charging
1. Insert AC charging adapter into charging jack of the unit.
2. Plug the other end of AC charging adapter into a wall socket. The blue charging LED
indicator will be illuminated while the unit is charging.
3. Fully charge the unit (average 2-4 hours continuously between uses).
4. When charging is complete, the four LEDs should be lit up. Unplug the AC charging adapter
from the wall socket first, then from the charging jack on the unit.
DC Charging in Your Vehicle
Engine must be running while charging the battery bank�
1. Turn the vehicle engine on.
2. Insert the DC charging adapter into the charging jack of the unit. The blue charging LED
indicator will be illuminated while the unit is charging.
3. Plug the other end of DC charging adapter into vehicle's cigarette lighter (DC) socket.
4. Fully charge the unit (around 3-5 hours continuous). Engine must running during entire charge.
5. When charging is completed, the four LEDs should be lit up. Unplug the DC charging adapter
from the vehicle first, then from the charging jack on the unit.
Wagan Tech and wagan.com are trademarks used by Wagan Corporation.
User's Manual—Read before using this equipment
©2014 Wagan Corporation. All Rights Reserved.
7