Using The Usb Socket; Led Flashlight; Care & Maintenance; Proper Disposal - Wagan Tech iOnBoost V6 Manual De Usuario

8. Place unit on a secure surface away from moving parts.
9. Start vehicle engine. Stop if the vehicle does not start after 4 to 5 seconds of engine
cranking. Disconnect the cables and wait 3 to 4 minutes, then try again. If engine does not
start after second attempt, discontinue and consult a professional.
10. When finished, disconnect the clamps in reverse sequence of connecting procedure—first
disconnect negative (black), then positive (red) clamps.

USING THE USB SOCKET

1. Connect the USB device to the battery bank with either a user-supplied cable or the included
4-in-1 USB adapter.
2. When your mobile device is fully charged, disconnect your device from the battery bank.
3. If the charge in the battery bank is low, the USB port will shut off to prevent damage to the
battery bank. Recharge the battery bank as soon as possible.

LED FLASHLIGHT

The light will automatically shut off before the battery bank runs out of power.
1. Hold down the power button until the indicator lights turn on (~3 seconds).
2. Press once to switch lighting modes (second press will turn the light off).
3. Recharge battery as soon as possible.
CARE & MAINTENANCE
This unit may be stored in any position. Make sure the clamps are secure inside the booster cable
storage covers and store at room temperature. If the battery bank is not used for a prolonged
period of time, recharge every 2 months in the winter time and every month in the summer time.

PROPER DISPOSAL

• This product has no consumer serviceable parts.
• Do not attempt to remove or replace the battery used in this device. When
the battery has reached the end of its lifetime, please take the entire unit to a battery
recycling facility.
Wagan Tech and wagan.com are trademarks used by Wagan Corporation.
User's Manual—Read before using this equipment
©2014 Wagan Corporation. All Rights Reserved.
9