Publicidad
Insert the sensor into the drilled hole and fix it securely with some
mounting glue if necessary). Then connect the connecting cable to
the switch module.
2.
Surface mount:
Mount the sensor with the screws provided. Then connect the
connection cable to the switch module.
Mount the LED Strip:
Mount the LED Strip in an aluminum profile.
Connect the wiring from the switch module of the PIR motion sensor
to the LED Strip and connect the input of the switch module to an
LED power supply. Connection diagram see page 3.
6.
Technical Specifications
Physical properties
Cable length
Maximum current rating
Input voltage rating VDC range
Detection range
Detection angle
drill diameter
Delay after trigger
IP rating
Operating temperature range
Use this device with original accessories only. Velleman Group
nv cannot be held responsible in the event of damage or
injury resulting from (incorrect) use of this device. For more
info concerning this product and the latest version of this
manual, please visit our website www.velleman.eu. The
information in this manual is subject to change without prior
notice.
V. 01 – 15/11/2023
LQS04
100 cm
3 A
12-24 V
1-3 m
110°
13 mm
45 seconds
IP20
-20-45 °C
7
©Velleman Group nv
Publicidad
