Lenco DAR-017 Manual Del Usuario página 11

Dynamic Label Segment (DLS): Displays scrolling text information supplied by the broadcaster.
Bit Rate: The data rate of which the signal is being transmitted.
DAB Mode- DRC
DRC is dynamic range compression, and it is about increasing the loudness of the quieter parts of
the audio signal, and decreasing the loudness of the louder parts.
In DAB mode, press the Menu button, then use the ok knob to navigate until "DRC" is highlighted.
Press the ok knob to confirm.
Now use the ok knob to cycle through off, high, low level. Press the ok knob to confirm your choice.
DAB mode- System settings
Sleep:
The device features a sleep timer function, which switches off the radio off after a certain time if no
actions have been performed up until then. Also you can enter sleep setting by press SLEEP button.
1. Rotate the knob to select either OFF-15-30-45-60-90 minutes.
2. Press the knob to confirm your selection.
Alarm Setting
Note: Check that the radio has the correct time and date before you set an alarm.
You can also enter Alarm setting by press the 'ALARM' button on the front of the radio.
Rotate knob to select 'Alarm 1' or 'Alarm 2' for setting.
When you select 'Alarm 1 ' and press ok knob, rotate the ok knob to "Alarm" and short press the ok
knob to switch the alarm on- or off.
Rotate the ok knob to scroll to 'frequency'. You can choose Daily, Once, Weekends or Weekdays.
Short press the ok knob to confirm your selection.
11