Hilti SL 2-A12 Manual Del Usuario página 18

2.3 Careful handling and use of batteries
▶ Observe the special guidelines applicable to the transport, storage and
use of lithium-ion batteries.
▶ Do not expose batteries to high temperatures, direct sunlight or fire.
▶ Do not disassemble, crush or incinerate batteries and do not subject
them to temperatures over 80 °C (176 °F).
▶ Do not use or charge batteries that have suffered mechanical impact,
have been dropped from a height or show signs of damage. In this case,
always contact your Hilti Service.
▶ If the battery is too hot to touch it may be defective. Put the battery in
a place where it is clearly visible and where there is no risk of fire, at an
adequate distance from flammable materials. Allow the battery to cool
down. If it is still too hot to touch after an hour, the battery is faulty.
Contact Hilti Service.
3 Description
3.1 Product overview
Multi-position hinge
@
LED bezel
;
LED
=
Retractable hook
%
Automatic switch
&
3.2 Intended use
The product described is a cordless lamp. It is intended for use as illumination
on jobsites. Use the product in a dry environment only.
SL 2-A12
Use only Hilti Li-ion batteries from the B 12 series with this product.
▶ Use only the Hilti battery chargers of the C 4/36 series with the CA-
B12 charging adapter, or battery chargers of the C 4/12-50 series for
charging these batteries.
SL 2-A22
Use only Hilti Li­ion batteries of the B 22 series with this product.
▶ Use only the Hilti battery chargers of the C4/36 series for charging these
batteries.
3.3 Charge state indicator
Lightly press (no more than until resistance is perceptible) either of the
battery release buttons to check the charge state of the Li­ion battery.
14 English
1
(
)
+
§
3-mode switch
Grip
Battery
Battery release button
2171355
*2171355*