Descargar Imprimir esta página

Panasonic ER-GP23 Instrucciones De Funcionamiento página 10

Ac/recortadora de pelo profesional

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 57
Charging (Fig. 2)
1
Connect the appliance plug to the stand socket.
2
Place the appliance on the charging stand.
3
Insert the adaptor into a household outlet.
• Check that the charge status lamp glows.
• Charging is completed after approx. 1 hour.
► Display while charging
While
charging
While
(Low battery
charging
capacity)
( :Glows,
4
Disconnect the adaptor after charging is completed.
<How to check that charging is completed>
Insert the main body again after removing it from the charging
stand. If the lamps glow and then turns off after 5 seconds,
charging is completed.
► Notes
• Recommended ambient temperature for charging is
10 °C – 35 °C. It may take longer to charge, or the charge
status lamp will blink quickly and the battery may fail to
charge properly in extremely high or low temperatures.
10
5 seconds
After charging
later after
is completed
charging is
completed
:Blinks, :Turns off)
• 1 full charge will provide approximately 100 minutes of
continuous operation. (Based on dry using at 20 °C – 30 °C)
The operating time may differ depending on the frequency of
use and the operating method.
• When charging the appliance for the first time or when it has
not been in use for more than 6 months, the charging time
may change or the charge status lamp may not glow for a
few minutes. It will eventually glow if kept connected.
• If there is noise from the radio or other sources while using
or charging the appliance, move to a different location to use
the appliance.
• The battery will deteriorate if not used for over 6 months, so
make sure to perform a full charge at least once every 6 months.
Charging without the charging stand (Fig. 3)
Plug the AC adaptor into the main body and the household outlet.
AC operation
If you connect the AC adaptor to the appliance in the same
way as for charging, and turn on the power, you can use it.
• The charge status lamp glows when using the AC operation.
• If the remaining battery is too low, the blades may move
slowly or stop, even with the AC operation. In this case,
charge the battery for 1 minute or more.
• The battery will be discharged, even with the AC operation.

Publicidad

loading