How to use
• Check that the blades are not damaged or deformed before use.
• Apply the lubrication oil to the blade before and after each
use. (See page 12.)
• The appliance may not operate in an ambient temperature
lower than approximately 5 °C.
• After use, turn it off and clean it.
► About setting the trimming height
1
Select the trimming heights indicated on the insides
and sides of the attachments.
2
Turn on the power.
► About the approximate remaining charge
High battery
capacity
( :Glows,
► Note
• The lamps will turn off approximately 5 seconds after
operating the switch. However, if the battery remaining is
low, it will not turn off and one battery capacity lamp and the
charge status lamp blinks. (When the power is turned off, the
lamps turn off after 5 seconds.)
Charging is required when the one battery capacity lamp and
the charge status lamp blinks. You can trim 5 minutes after
this is displayed. (This will differ depending on usage.)
Removing and mounting the comb attachments
► Mount (Example: 6 mm comb attachment) (Fig. 4)
Slide the attachment until it clicks.
► Remove (Fig. 5)
Remove the attachment by pressing with your thumb.
Maintenance
• Make sure that the main body is turned off.
• Clean the main body, blade and the comb attachment after
each use.
(If not cleaned, the motion will become poor and the sharpness
will worsen.)
• Lubricate after cleaning.
• Do not use thinner, benzine or other chemicals. Doing so
Low battery
may cause failure, cracking or discoloration of the parts.
capacity
Clean the main body only with a soft cloth slightly dampened
with tap water or soapy tap water.
How to clean
► Main body, Blade
1. Brush off any hairs from the main body and from around the
:Blinks, :Turns off)
blade. (Fig. 6‑1)
2. Brush off the hairs from the blade edge. (Fig. 6-2)
3. Brush any hair trimmings out from between the stationary
blade and the moving blade while pressing down the
cleaning lever (a) to raise the moving blade. (Fig. 6‑3)
► Charging stand (Fig. 7)
Use the cleaning brush to clean hair trimmings and dust in the
charging plug or in the hole on the bottom surface.
11