Matikgate HULK Manual De Usuario/Instalador página 57

This engine has error indications as per table below.
CODE
Err 1 Encoder signal anormalities
Err 2 Door operation timeout.
Err 3
Door block or stall.
1. Chain is ectopic
Err 4
2. Motor overheating protection
Stop Emergency button.
Err 6
Service door security.
Err 7
Triggered photocells.
Err 8 Closing lock.
Err 9
(função
1. Power supply with phase lack.
apenas
disponível
2. Power supply phase error.
nos quadros
trifásicos)
TROUBLE
Fuse blown.
Photocell device short-circuit.
No reaction
when power on
Surface of console short-circuit.
Encoder short-circuit.
Motor wire open circuit.
Motor doesn't
run
Parameter setting error.
Battery runs out.
Weak signal.
Remote control
Transmitter is immersed with water or
has not reaction
broken.
It is not programmed.
Wires are connect wrong.
Press the open
button but the
door is closed
Check DI security.
ERROR CODES TABLE
MEANING
TROUBLE SHOOTING
CAUSE
SOLUTION
Check encoder signal wires and connec-
tions.
Check the operation of the door.
Check the motor and rail.
1. Pull the chain back and forth to make it
resert.
2. Stop running and wait for motor cooling.
Rotate button clockwise to make it resert.
Close the service door or do the safety
shunt.
Remove the object that blocks the photocell
or do the safety shunt.
Check the connection or the security sys-
tem.
1. Check the circuit.
2. Power off, remove any two power cord
on control board, and exchange the or-
der, then connect with control board.
SOLUTION
Replace the fuse.
Check the photocell device.
Check the surface of console.
Check the encoder.
Check the wiring.
Resert "P--1", "P--2", DIP switch first.
Replace with new battery.
Avoid the obstacles and interference
sources.
Replace the remote control
Programming transmitter (pag. 48).
Swap the motor wires "L1" and "L2"
(single phase motor) / Swap any 2 motor
wires (three phase motor).
Shunt or overhaul the security system of
the service door.
EN
57
MATIKGATE AUTOMATION