brendz 560KOCHI Manual De Usuario página 18

GB | Irrigation kit for flower pots
2
Read this manual carefully before using the product.
The kit contains:
1
4
3
6
6
5
Installation steps (Fig. 1)
1. Connect the pressure regulator to your gardenhose.
2. Connect the tubing to the regulator.
3. Connect the joints to the tubing.
4. Secure the tubing in the flower pots using the spikes.
Note: To make it easier to connect the hose to the fittings, put the end of the tube in hot water for 10 sec.
Clean the drippers with the dripper cleaner in case it does not let any or just little water through.
(Fig. 2)
Care and Maintenance
The product is designed to provide trouble-free service for many years if used appropriately.
Some advice for proper operation:
• Do not place any open flame sources on the product, e.g., a lit candle, etc.
• To clean the product, use a slightly moistened soft cloth. Do not use solvents or cleaning agents.
• In the event of damage or defect of the product, do not perform any repairs by yourself. Have it
repaired where you purchased the product.
• This product is not intended for use by persons (including children) whose physical, sensory, or
mental disability or lack of experience and expertise prevents them from safe use of the product if
they are not supervised or if they have not been instructed regarding the use of this product by a
person responsible for their safety. It is necessary to supervise children to ensure they do not play
with the product.
Φ 1/4"
Φ 3/16"
1× Pressure
Φ 4-6 mm
regulator
Φ 1/4"
1× L-Joint
Φ 3/16"
Φ 4-6 mm
20× T-Joint
+ endline drip
head 2L/H
Φ 1/4"
Φ 3/16"
Φ 4-6 mm
3
2
5
4
7
7
12× Pipe spike
4
Φ 1/4"
1× hose (10 m)
Φ 3/16"
Φ 4-6 mm
1/4"
Ø4-6mm
6
Φ 1/4"
2x Plug
Φ 3/16"
Φ 4-6 mm
2× Drip Head
Cleaner