EZiclean Windobot S5 Guía Rápida página 4

Step 1. Connect the adapter and DC extension cord to ROBOT correctly.
Step 2. Make sure the safety battery is fully charged (green light ON) before the first using:
- Plug it into a power source. Orange light ON means charging.
- Green light ON means the battery is fully charged.
Step 3. Make sure to put the cleaning cloth onto the device correctly to avoid air leakage.
- The robot has 4 detective sensors for detecting glass edge. These sensors cannot be covered by cleaning
cloth like pictures as shown.
- Put cleaning cloth onto device flatly and do not let cloth cover the caterpillar wheel and these four sensors.
Step 4. Fill the water tank with EZICLEAN solution and tighten the tank lid fully after filling.
Step 5. Place your robot on the glass.
- Turn power switch on make sure fan is working.
- Put robot onto window and keep 10cm away from the window frame.
- Check the robot sticks to the window before releasing it.
Step 6. Operate the robot via different methods.
- Press the button of the robot, start auto-up cleaning with auto-spraying.
- Operate the robot by remote control, you could press central "OK" button to start the robot's auto cleaning
modes.
Step 7. Finish cleaning and remove the robot.
- After cleaning, the robot will stop at the lower edge of the window.
- Firmly grasp the handle and turn off the robot's power supply .
ENGLISH