Publicidad
Idiomas disponibles
Idiomas disponibles
• Connect
the speaker
terminals
with
the speakers
makk_g sure that like polarities are matched (_ with
_, _ with e)
Mismatching
of polarities will result
in weak
central
sound,
unclear
orientation
of the
various instruments,
and the sense of direction of the
stereo being _mpaired
• When
making
connections,
take care that none of
the individual conductors
of the speaker cord come
in contact with adjacent terminals, with other speaker
cord conductors,
or with the rear penel
NOTE:
NEVER touch the speaker terminals
when the
power is on,
Doing so could result in electric shocks.
Speaker Impedance
• When
speaker systems
A and B are use separately,
speakers with an impedance
of 6 to 16 £_ohms can
be connected
for use as front speakers¸
• Be careful when
using two pairs of front speakers
(A + B) at the same time, since use of speakers with
an impedance
of 12 to 16 _/ohms
• Speakers with an impedance
of 6 to 16 _2/ohms can
be connected tot use as center and surround speakers
• The protector
circuit
may be activated
if the set is
played for long periods of time at high volumes when
speakers with an impedance lower than the specified
impedance
are connected
• This unit is equipped
with a high-speed
protection
circuit
The purpose of this circuit is to protect
the
speakers under circumstances
such as when the output of the power amplifier
is inadvertently
shot[-
circuited and a large current flows, when the temperature
surrounding
the unit becomes
unusually high,
or when the unit is used at high output over a long period which results in an extreme
temperature
rise
When the protection
circuit
is activated,
the speaker output
is cut off and the power
supply indicator
LED flashes
Should this occur, please follow these steps: be sure to switch
off the power of this unit,
check whether
there are any faults with the wiring
of the speaker cables or input cables, and wait for
the unit to cool down if it is very hot
Improve the ventilation
condition
around the unit and switch
the
power back on
If the protection
circuit
is activated
again even though there
are no problems
with
the wiring
or the
ventilation around the unit, switch off the power and contact a DENON service center
Connecting
the speaker cords
1 Looserlbyturllirlg
2 Irlsertthecord
3 Tightenbyturnlng
cou_terclockwise
clockwise
CENTERSPEAKER
I sYsTE.
I E R° SP 'ERSYSTE"S1
I'RON'SPE'KERS'ST "S
System A
System B
Connection
iack for subwoofer
w_th
built _n amplifier
(supel woofer),
etc
_4 To achieve
Dolby
Digital
(AC 3)
playback
effect,
use a unit that can
sufficiently
reproduce
frequencies
of under 80 Hz
D=, @=_
screen may be disturbed by the
I SURROUND SPEAKERSYSTEMS ]
speaker's magnetism _f th_sshouM
happen, move the speaker away
to a pos_t_or_ where it does not have
this effect
• The protector
circuit may be activated if the set is played for long periods of time at high volumes when
speakers with an impedance lower than the specified impedance (for example speakers with an impedance
of lower than 4 _2/ohms) are connected
If the protector circuit is activated, the speaker output
is cut off
Turn off the set's power, wait for the set to cool down, improve the ventilation around the set, then turn
the power back on
8
Publicidad
