Moving Or Storage Preparation; Reinstalling/Using Washer Again; Electrical Shock Hazard - Haier HLP21N Manual Del Usuario

MOVING OR STORAGE PREPARATION

In addition to performing the "Vacationing Precautions," complete the following
additional steps.
•
Unplug or disconnect power.
•
Disconnect the water hose and the drain hose and place them into the wash
basket.
•
Turn the leveling feet so that they are fully retracted into the washer cabinet.
•
If moving the washer, place the wash basket brace from the original packing
materials back into the top of the washer opening. Use masking tape to secure
the washer lid.
•
Move and store your washer in an upright position only.
•
Do not store your washer in a cold environment where temperatures fall below
freezing; store at room temperature.

REINSTALLING/USING WASHER AGAIN

Plug into a grounded 3 prong outlet.
Do not remove the ground prong from the power cord plug.
Do not use an adapter.
Do not use an extension cord.
Failure to do so can result in death, re or electrical shock.
To reinstall washer after non-use, vacation, winter storage or moving:
1. Refer to Installation Instructions to locate, level, and connect washer.
To use washer again:
Before using again, run washer through the following recommended procedure:
1. Flush water pipes and hoses. Reconnect water inlet hoses. Turn on both water
faucets.
2. Plug in washer or reconnect power.
3. Run washer through Wash cycle to clean washer and remove antifreeze, if used.
NOTE: Use only HE High Efficiency detergent. Use half the manufacturer's
recommended amount for a medium-size load.
26
WARNING

Electrical Shock Hazard