Costway NP10835 Instrucciones De Montaje página 5

● NOTICE: There are four
holes in each leg for
adjusting the height of the
canopy. Do not fully extend
legs downward at this time.
Gently lift one outer frame
leg and pull open the frame
partially until you extend the
frame to a full arm's
length-approx. 123cm(Fig.2).
● Place the small top cover
on the small top frame and
canopy fabric over the
partially opened frame.
Leave one corner of the
fabric a bit loose to leave
space for opening the frame
fully later(Fig.3).
● Step underneath the tent
and firmly push the centered
frame handle upward until
the damps snap into place
and rest securely over the
frame brace(Fig.3 and 4).
● Use the hook and loop
straps to secure each corner
of the fabric to the upper
portion of each leg and
secure remaining hook and
loop straps to the frame
(Fig.5).
● Push up the wind
resistance levers on four
sides after the whole tent is
opened.
08
Fig.2
Fig.3
Fig.4
Frame Brace
Clamp
Clamp
Handle
Set Up and Use
Instructions
Read all instructions before
use!
● Select location for tent.
● Remove the tent from the
carrying case.
● Push inward on one of the
levers located inside of the
tent frame legs, and pull out
the extension from the top
portion of the leg to the 1st
level. Repeat for the
remaining legs(Fig.1).
NOTICE: There are four holes
in each leg for adjusting the
height of the tent. Do not fully
extend legs downward at this
time.
● Gently lift one outer frame
leg and pull open the frame
partially until you extend the
frame to a full arm's
length-approx. 123cm(Fig.2).
● Step underneath the tent
and firmly push the centered
frame handle upward until the
clamps snap into place and
rest securely over the frame
brace(Fig.3 and 4).
Fig.5
Fig.6
Stakes Bracing Legs
Fig.7
Stakes Bracing Anchor Ties
09