Costway NP10835 Instrucciones De Montaje página 6

● Extend the leg to the desired height(second or third hole from the
bottom of the leg) push inward on the lever located inside of a leg, and
release to insert the safety pin into the selected hole. Repeat to adjust
each remaining leg(Fig.1).
Secure the placement of the tent by:
● inserting the stakes through the ends of the legs(Fig.6).
● unfolding the four guy cords, locating on the top, outside corners of the
tent, extending the guy cords to ground level, securing the end of the guy
cords to ground stakes, and then Inserting the ground stakes into the
ground (Fig.7). WARNING:The guy cords and ground stakes can present
a tripping hazard, resulting in serious personal injury. Use extra caution
near the guy cords and ground stakes when the product is in use and
during assembly/disassembly.
To Disassemble and Store
● Remove ground stakes
from the ends of the legs or
from the ends of the guy
cords.
Push inward one of the
levers located inside of the
legs and release the safety
pin from the hole in the leg,
and lower the height of the
tent. Repeat for the
remaining legs (see Fig.8).
● Release the clamps
securing the handle to the
frame brace by pressing the
clamps inward and pulling
down on the handle(see
Fig.9).
10
Fig.8
Frame Brace
Clamp
Clamp
Handle
Fig.9
● Step out of the tent. Gently
lift one leg and push inward
until the frame is folded(see
Fig.10). NOTICE:Do not use
excessive force when
disassembling the tent. If the
frame or canopy feels stuck
and will not close, slightly
open the legs again, gently
jiggle the frame and canopy,
and then continue pushing
the legs inward.
● Place the folded tent
horizontally on a flat surface.
● Push inward one of the levers located inside of the legs,release the
safety pin, and slide the leg upward into the top portion of the leg. Repeat
for the remaining legs(see Fig.11).
Care and Maintenance
● Lower the tent during inclement weather and immediately after each
use.
● Always make sure the canopy is dry before storing the product, to avoid
product damage from mold and mildew.
Do not use abrasive cleaners or pads to clean the product.
● After each use and to remove loose dirt or debris, wipe the metal frame
with a soft, dry doth before storing.
Fig.10
Fig.11
11