Descargar Imprimir esta página

Poulan Pro PPB5000P Manual De Instrucciones página 8

Publicidad

Idiomas disponibles

Idiomas disponibles

REMOVING
PRUNER
ATTACHMENT
(OR OTHER OPTIONAL
ATTACH-
MENTS)
CAUTION:
Whee removing or installing at-
tachments, place the powerhead and attach-
ment on a flat surface for stability.
1. Loosen
the coupler
by turning
the knob
counterc(ockwise.
Upper Shaft
Coupler
Lower
\
Attachment
TIGHTEN
Knob
2. Press and hold the (ocking/release
button.
Locking/Release
Button
/
Lower Attachment
Upper Shaft
3. While securely holding the upper shaft, pull
the attachment
straight out of the coupler.
INSTALLING
OPTIONAL
ATTACH-
MENTS
1. Remove the shaft cap from the attachment
(if present)
and discard.
2. Position
iocking/release
button of attach-
ment into guide recess of upper shaft cou-
pler.
3. Push the attachment
into the coupler
until
the locking/release
button snaps
into the
primary hole.
4. Before using the unit. tighten the knob se-
curely by turning clockwise.
Coup(er
Primary
Hole
Guide Recess
Upper
Locking/
Attachment
Shaft
Release
Button
rmWARNING:
Make sure the locking/
release
button
is locked
in the primary
hole
and the knob is securely
tightened
before op-
erating
the unit. Using the wrong
hole could
lead to serious injury or damage to the unit.
Secondary
Hole
Locking/Release
Button in Primary
Hole
BAR
AND
CHAIN
LUBRICATION
The
bar and chain require
lubrication.
The
chain oiler provides
continuous
lubrication
to
the chain and guide bar. Be sure to fill the bar
o)1 tank
before use (Capacity
= 4.6 fl. oz.).
Lack of oil will quickly ruin the bar and chain.
Too little oil will cause overheating
shown by
smoke coming from the chain and/or discolor-
ation of the bar. The oil output is automatically
metered during operation.
Genuine
Poulan
or Poulan
PRO
bar and
chain oil is recommended
to protect your unit
against
excessive
wear from heat and fric-
tion. Poulan or Poulan
PRO
oil resists high
temperature
thinning.
If Poulan
or Poulan
PRO
bar and chain oil is not available,
use a
good grade SAE 30 oil.
• Never use waste oil for bar and chain lubri-
cation.
• Always
stop the engine
before
removing
the oil cap.
INSTALLING
ATTACHMENT
HANGER
An attachment
hanger is provided for storage
when attachment
is not in use.
To install hanger on attachment:
1. Removethe
shaft cap from the attachment
(if present) and discard.
2. Press and hold the locking/release
button.
3. Push hanger onto the attachment
until the
locking/release
button snaps into the hole.
OPERATING
POSITION
ALWAYS_WEAR:
,_ .
_"t,
Head
}¢.-,,t,
,
_,.
Protection
F
\
Eye
i
!4L eovyShoes
A0&DANGER:
Do not extend arms above
shoulders
while
pruning.
Do not stand
be-
neath branch being cut.

Publicidad

loading