Maintenance And Inspection - Metabo HPT DB 3DL2 Manual De Instrucciones

MAINTENANCE AND INSPECTION

CAUTION
Pull out battery
inspection or maintenance.
1. Checking the condition of the bit
The bits should be checked regularly. If worn or
broken bits can slip or decrease the effi ciency
of the motor and burn it out.
Replace worn bits with new ones.
CAUTION
If you use a driver bit of which point is
worn or broken, it will be dangerous since
it slips. So replace it with a new one.
2. Check the screws
Loose screws are dangerous. Regularly inspect
them and make sure they are tight.
CAUTION
Using this power tool with loosened screws
is extremely dangerous.
3. Check for dust
Dust may be removed with a soft cloth or a cloth
dampened with soapy water.
Do not use bleach, chlorine, gasoline or thinner,
for they may damage the plastics.
4. Disposal of the exhausted battery
WARNING
Do not dispose
battery. The battery must explode if it is
incinerated. The product that you have
purchased contains a rechargeable battery.
The battery is recyclable. At the end of it's
useful life, under various state and local
laws, it may be illegal to dispose of this
battery into the municipal waste stream.
Check with your local solid waste offi cials
for details in your area for recycling options
or proper disposal.
before doing any
of the exhausted
5. Storage
Storing in a place below 104°F (40°C) and out
of the reach of children.
NOTE
Storing lithium-ion batteries
Make sure the lithium-ion batteries have been
fully charged before storing them.
Prolonged storage (3 months or more) of
batteries with a low charge may result in
performance deterioration,
reducing battery usage time or rendering the
batteries incapable of holding a charge.
However, signifi cantly reduced battery usage
time may be recovered by repeatedly charging
and using the batteries two to fi ve times.
If the battery usage time is extremely short
despite repeated charging and use, consider
the batteries dead and purchase new batteries.
6. Service and repairs
All quality power tools will eventually require
servicing or replacement of parts because
of wear from normal use. To assure that only
authorized replacement parts will be used,
all service and repairs must be performed
by a metabo HPT AUTHORIZED SERVICE
CENTER, ONLY.
CAUTION
In the operation and maintenance of power
tools, the safety regulations and standards
prescribed in each country must be
observed.
English
signifi cantly
15