Assembly And Operation; Removal And Installation Method Of Battery; Charging Method - Metabo HPT DB 3DL2 Manual De Instrucciones

English

ASSEMBLY AND OPERATION

APPLICATIONS
○ Use as a drill
Drilling of soft steel, plastic and aluminum
materials
○ Use as a screwdriver
Tightening and loosening of machine screws,
wood screws and tapping screws
REMOVAL AND INSTALLATION
METHOD OF BATTERY
○ How to install the battery
Align the battery with the groove in tool handle
and slip it into place.
Always insert it all the way until it locks in place
with a little click. If not, it may accidentally fall
out of the tool, causing injury to you or someone
around you. (Fig. 3)
○ How to remove the battery
Withdraw battery from the tool handle while
pressing the battery release buttons (2 pcs.) on
the sides of the battery. (Fig. 3)
Insert
Pull out
Battery

CHARGING METHOD

NOTE
Before plugging into the receptacle, make sure
the following points.
○ The power source voltage is stated on the
nameplate.
○ The cord is not damaged.
WARNING
Do not charge at voltage higher than
indicated on the nameplate.
If charged at voltage higher than indicated
on the nameplate, the charger will burn up.
10
Handle
Battery release button
Push
Fig. 3
1. Insert the plug of battery charger into the
receptacle.
WARNING
Do not use the electrical
cord if damaged. Have it
repaired immediately.
2. Insert the battery to the battery charger.
Insert the battery into the battery charger as
shown in Fig. 4.
Battery
3. Charging
○ When the battery is connected to the battery
charger, charging will commence and the pilot
lamp will light on.
NOTE
If the pilot lamp does not light, pull out the plug
from the receptacle and check if the battery is
properly mounted.
○ When the battery is fully charged, the pilot lamp
will go out.
Pilot lump
Fig. 4