Publicidad
Idiomas disponibles
Idiomas disponibles
Operating tips
Opening and closing the refrigerator
compartment doors
The refrigerator compartment doors can be opened
and closed independently.
The left refrigerator compartment door has a foldaway
door bar.
NOTICE
Risk of damage to the appliance!
The door bar could become damaged if you attempt
to close the left refrigerator compartment door when
the door bar is not folded back.
Before closing the refrigerator compartment doors,
make sure that the door bar is folded at a right angle
to the door.
When closing the left refrigerator compartment door,
the door bar folds behind the right refrigerator
compartment door, forming a seal between the
refrigerator compartment doors.
Switching on the appliance
NOTICE
After installing the appliance, wait at least 6 hours
before plugging in the appliance. The oil in the
compressor may have flowed into the refrigeration
system during transport.
Connect the appliance plug to the outlet.
After the appliance has been plugged in, the
refrigeration process will begin. The interior light in the
refrigerator compartment switches on when the door
is open.
It will take several hours for the inside of the appliance
to reach the temperatures set at the factory. Do not
place food in the appliance until these temperatures
are reached.
Initial temperature
Refrigerator compartment: 39 °F (+4 °C)
Freezer compartment: 0 °F (-18 °C).
Setting the temperature
Freezer compartment
The temperature can be adjusted between
9 °F (-13 °C) up to -8 °F (-22 °C).
1. Press the "Freezer Temp. –" or the "Freezer
Temp. +" button.
The freezer compartment temperature illuminate.
2. Repeatedly press the "Freezer Temp. –" or the
"Freezer Temp. +" button until the desired freezer
compartment temperature is set.
The temperature cannot be set circularly; every time
the temperature will increase by 1 °F (1 °C) after the
button is pressed once.
After the temperature adjustment is completed, the
new temperature setting will be active for 15 seconds
after button was pressed.
We recommend a setting of 0 °F (-18 °C).
en-us
13
Publicidad
