Johnson Livestrong LS10.0E Manual Del Propietário página 13

ASSEMBLY STEP 3
CONSOLE MAST
PRE-INSTALLED BOLTS
& WASHERS
CONSOLE CABLE
MAIN FRAME
GUIDE RAIL
PEDAL ARM WHEEL
NOTE: Be
careful not
to pinch any
wires while
attaching the
console mast.
CRANK
PEDAL ARM
WAVY WASHER (J)
FLAT WASHER (D)
SPRING WASHER (B)
BOLT (K)
HARDWARE FOR STEP 3:
WAVY SPRING
WASHER (J) WASHER (B)
22.5 mm 15 mm
Qty: 2 Qty: 2
Open HARDWARE FOR STEP 3.
A
Remove PRE-INSTALLED BOLTS AND
B
WASHERS from MAIN FRAME.
Carefully pull the CONSOLE CABLE through
C
the CONSOLE MAST using the twist tie located
inside the CONSOLE MAST.
Attach CONSOLE MAST to MAIN FRAME
D
using PRE-INSTALLED BOLTS AND
WASHERS.
Slide WAVY WASHER (J) over CRANK
E
followed by PEDAL ARM as shown. Rest
PEDAL ARM WHEEL on GUIDE RAIL.
Attach the PEDAL ARM to the CRANK using
F
1 FLAT WASHER (D), 1 SPRING WASHER
(B) and 1 BOLT (K).
Repeat steps E–F on the opposite side of the
G
elliptical.
FLAT BOLT (K)
WASHER (D) 20 mm
20 mm Qty: 2
Qty: 2
13