BOMANN ES 1906 CB Instrucciones De Servicio/Garantía página 41

Troubleshooting
Malfunction Possible Causes
When the The device has no
function se- power supply.
lector switch
is operated
the device
does not
switch on.
Coffee stops
The water tank is
fl owing. empty.
The tank is not
correctly inserted, the
valve is not open.
The holes in the fi lter
holder and the outlet
on the brewing head
are blocked.
Air has entered the
„heating element".
Coffee is too fi ne or
pressed too fi rm.
Scale has accumu-
lated in the espresso
machine.
The pump Water tank is empty. Switch off the
makes loud
noises.
There is air in the
water system.
The tank is not
inserted correctly, the
valve is not open.
The espresso
The Filter is in the
comes out wrong position or
of the edge is not closed fi rm
of the fi lter enough.
holder.
Coffee is on the
rubber gasket.
Too much coffee in
the fi lter.
05-ES 1906 CB 41
Remedy Malfunction
Check the socket with The espresso
another device and coffee is too
cold.
insert the mains plug
correctly.
Switch off the device
and fi ll up the water
tank.
The coffee
Press the tank down
has a slightly
slightly so that the
acidic taste.
valve opens.
The coffee
Clean the fi lter holder,
foam is slight-
the fi lter and the
ly discoloured
outlet on the brewing
(the coffee
head.
fl ows out
Produce some steam quickly).
(see the section
The coffee
„Preparing Cappuc-
foam is a dark
cino") and turn the
colour (the
steam regulator to the
coffee only
highest level.
fl ows out
slowly).
Loosen the coffee
powder.
The coffee is
not creamy
The appliance needs
enough.
de-scaling.
device and fi ll up the
container.
Fill the water tank
and remove air from
The milk is not
the machine (see the
foamed up.
section „Initial Use/Air
Removal").
Press the tank down
lightly so that the
valve opens.
Remove the fi lter than
refi t or switch off the
machine and tighten
Model: ........................................................................ES 1906 CB
the fi lter.
Power supply:............................................................230 V, 50 Hz
Please wipe off.
Power consumption:...........................................................1150 W
Remove any excess
Protection class:........................................................................... Ι
coffee powder.
Pressure:..............................................................................15 bar
This device has been tested according to all relevant current
CE guidelines, such as electromagnetic compatibility and low
voltage directives, and has been constructed in accordance with
the latest safety regulations.
Subject to technical changes without prior notice!
Possible Causes Remedy
The cups were not Rinse out the cups
warmed beforehand. with hot water.
The heating up Please wait for the
phase had not been heating up phase to
completed. fi nish.
During preparation Please wait until the
of the coffee the „ control lamp lights up.
/ " lamp has not
yet gone on.
The espresso was
not fresh.
Coffee too coarse Use the tamper.
or not pressed fi rm
enough.
There is not enough Fill in more coffee
coffee in the fi lter. powder.
Coffee too fi ne or Loosen the coffee
pressed to fi rm. powder.
Too much coffee in Remove any excess
the fi lter. coffee powder.
The adapter is not Insert the adapter
correctly inserted. correctly.
The second sealing Insert the ring
ring in the fi lter correctly.
holder is not correctly
inserted.
Wrong coffee was Change the brand if
used. necessary.
The milk used is not Check the fat content.
suitable. Use low-fat milk.
The milk is not cold Use cooled milk.
enough.
The steam nozzle Clean the steam
is dirty. nozzle.
Technical Data
31.05.2006, 14:16:30 Uhr
41