Publicidad
Idiomas disponibles
Idiomas disponibles
9. CONNECT
THE TUBING
TO THE
REFRIGERATOR
NOTE:
• Before making the connection to the refrigerator, be
sure the refrigerator power cord is not plugged into
the wall outlet.
• If your refrigerator does not have a water filter,
we recommend installing one if your water supply
has sand or particles that could clog the screen of
the refrigerator's water valve. Install the filter in the
water line near the refrigerator.
1. Remove the plastic flexible
cap from the water valve.
2. Place the compression nut
and ferrule (sleeve) onto
the end of the tubing as shown.
©
3. Insert the end of the copper tubing into the
connection as far as possible. While holding the
tubing, tighten the fitting.
10. TURN THE WATER
ON AT THE
SHUTOFF
VALVE
Tighten any connections that leak.
Reattach the compressor compartment access cover.
11. PLUG IN THE REFRIGERATOR
Arrange the coil of tubing so that it does not vibrate
against the back of the refrigerator or against the
wall. Push the refrigerator back to the wall.
n
_.
CAUTION: Check to see if leaks occur at water line
connections.
Tubing Cla_
1/4 "Tubing
l
Refrigerator
Connection
%
%
12. START THE ICEIVlAKER
Set the icemaker power switch to the ON position.
The icemaker will not begin to operate until it reaches
its operating temperature of 15°F (-9°C) or below. It
will then begin operation automatically
if the
icemaker power switch is in the I (on) position.
P_ CAUTION: Check to see if water dripping occurs at
water line connections.
27
Publicidad
