Note: For diving in cold water (below 10°C), it is highly advisable to use
two independent cold water regulators.
Attention: A regulator with a balanced 1st stage must be assembled to a
balanced 2nd stage Octopus.
IMPLEMENTATION
A regulator must be used in combination with a pressure gauge. The
regulator can mounted on a diving cylinder in either of two configura-
tions :
RECOMMENDATIONS : This regulator, complying with EN 250, is not
intended for more than one diver to breathe from at the same time.
If this regulator is configured and used by more than one diver at the
same time, then cold water and breathing performance may not fulfill
the requirements of EN 250.
A regulator will offer optimum performance in the following situations :
high pressure (HP) ports of 7/16".
Buoyancy compensators LP hose and drysuit hose can be installed on
available LP ports. The pressure gauge needs to be installed on the HP
port. For added security, the use of a cylinder with dual outlet valve
(Y-valve) will allow for a secondary back-up regulator.