Descargar Imprimir esta página

Craftsman 358.795530 Manual De Instrucciones página 7

Publicidad

Idiomas disponibles

Idiomas disponibles

When operating unit, s tand asshown
andcheck f orthefollowing:
* Wear e yeprotection andheavy
clothing.
* Hold trigger h andle w ithright h and
and assist handle w ithlefthand.
* Keep unitbelow waist l evel.
* Cut o nly from your r ight t oyour l eftto
ensure debris i sthrown a way f rom
you.Without bending over, keep line
near a ndparallel tothe ground a nd
not c rowded into material being c ut.
Donotruntheengine
a t a higher
speed than necessary. The cutting
line will cut efficiently when the engine
is run at less than full throttle. At lower
speeds, there is less engine noise and
vibration. The cutting line will last
longer and will be less likely to "weld"
onto the spool.
Always release the throttle trigger and
allow the engine to return to idle
speed when not cutting.
To stop engine:
Release the throttle trigger.
Move the ON/OFF switch to the OFF
position,
TRIMMER LINE ADVANCE
The cutting head advances line au-
tomatically.
Do not tap head on the
ground to advance line. This may
break parts and cause cutting head to
malfunction,
Upon unit start up, the line will advance
automatically to the correct cutting path
length.
Always keep the shield in place when
the tool is being operated.
4J_ WARNING:
Use only 0.080
inch (2 mm) diameter round line.
Other sizes and shapes of line will not
advance properly and will result in im-
proper cutting head function or can
cause serious injury. Do not use other
materials such as wire, string, rope,
etc. Wire can break off during cutting
and become a dangerous missile that
can cause serious injury.
CUTTING METHODS
_WARNING:
Use minimum
speed and do not crowd the line when
cutting around hard objects (rock,
gravel, fence posts, etc.), which can
damage the trimmer head, become
entangled in the line, or be thrown
causing a serious hazard.
• The tip of the line does the cutting.
You will achieve the best perform-
ance and minimum line wear by not
crowding the line into the cutting
area. The right and wrong ways are
shown below.
Tip of the Line
I
Line Crowded Into
D0es The CUtting
Work Area
Right
-=* "_
I Wrong ;'_
• The line will easily remove grass
and weeds from around walls,
fences, trees and flower beds, but it
also can cut the tender bark of trees
or shrubs and scar fences. To help
avoid damage especially to delicate
vegetation or trees with tender bark,
shorten line to 4-5 inches (10-13
cm) and use at less than full throttle.
• For trimming or scalping, use less
than full throttle to increase line life
and decrease head wear, especially:
• During light duty cutting.
• Near objects around which the line
can wrap such as small posts,
trees or fence wire.
• For mowing or sweeping, use full
throttle for a good clean job.
TRIMMING
- Hold the bottom of the
trimmer head about 3 inches (8 cm)
above the ground and at an angle. Al-
low only the tip of the line to make
contact. Do not force trimmer line into
work area.
Trimming
__
3 inches (8 cm)
above ground
_'_-'=_'4._'=_'_4:
SCALPING
- The scalping technique
removes unwanted vegetation down
to the ground. Hold the bottom of the
trimmer head about 3 inches (8 cm)
above the ground and at an angle. Al-
low the tip of the line to strike the
ground around trees, posts, monu-
ments, etc. This technique increases
line wear.
7

Publicidad

loading