Pioneer KEH-2300R Manual De Instrucciones página 23

PTY Alarm
ALARM is a special PTY code for emergency
announcements, such as natural disasters.
When the radio alarm code is received
"ALARM" lights in the display and the
volume changes. When the station stops
broadcasting the alarm, the system returns
to its previous source.
To return to the previous source during an
ALARM broadcast
Tuning Steps
The tuning step is normally set to 50 kHz
during seek tuning on an FM band.
However, this tuning step changes to 100
kHz when the AF or TA mode is activated. In
some countrtes it may be desirable to set a
50 kHz tuning step for the AF mode. You can
do this by halding down the [1] button while
turning the ignition key from OFF to either
ACC or ON.
Note
¢ The PTY Alarm will not operate from the
cassette mode if the tuner was last set to
the MW/LW band.
¢« Only the VOLUME [+] /I-], [TA] , [AF] , and
[SOURCE] buttons are active during PTY
alarm.
Press the [TA] button.
¢ During manual tuning the step does not
change; it remains fixed at 50 kHz. _
+ The tuning step will return to 100 kHz if the
battery supply is temporarily disconnected.
« In AF mode, only those stations broadcast
at 100 kHz steps are will be received
(CENELEC STANDARD).
23