Descargar Imprimir esta página

Craftsman 917.377530 Manual De Instrucciones página 16

Publicidad

Idiomas disponibles

Idiomas disponibles

IGtNE OIL
ainoil(with engine warm) and replace
_h clean engine o il (See "ENGINE" in
:_ Customer Responsibilities
section ofthis
:muaI).
ILINDER
Remove spark plug.
Pour one ounce (29 ml) of oil through
spark plug hole into cylinder.
Pull starter handle slowly a few times to
distribute oil.
Replace with new spark plug.
THER
Do not store gasoline from one season to
another.
Replace your gasoline can if your can
starts to rust. Rust and!or dirt in your
gasoline will cause problems.
If possible, store your unit indoors and
cover it to give protection from dust and
dirt.
Cover your unit with a suitable protective
cover that does not retain moisture.
Do
not use plastic
Plastic cannot breathe
which allows condensation to form and
will cause your unit to rust.
IMPORTANT:
Never cover mower while
engine and exhaust areas are still warm.
CAUTION:
Never store the lawn
mower with gasoline
in the tank inside a
building where fumes may reach an
open flame or spark.
Allow the engine
ROUBLESHOOTING
CHART
PROBLEM
Does not start
CAUSE
- Dirty air filter.
, Out of fuel.
• Stale fuel.
,, Water in fuel.
e
Q
®
, Spark plug wire is
disconnected.
• Bad spark plug.
, Loose blade or broken blade
®
adapter.
, Control bar in released
position.
o Control bar defective.
CORRECTION
Clean/replace
air filter.
Fill fuel tank.
Drain tank and refill with
fresh clean fuel.
Drain fuel tank and
carburetor and refill tank
with fresh gasoline.
Connect wire to plug.
Replace spark plug.
Tighten blade bolt or
replace blade adapter.
Depress control bar to
handle.
Replace control bar.
16

Publicidad

loading