Craftsman 917.377530 Manual De Instrucciones página 4

These accessories were available when t hislawn mower was produced. They arealso
available atmost Sears r etail outlets and service c enters. Most S ears s tores c analso
order r epak p arts f oryou, w hen youprovide themodel number ofyour l awn mower. Some
ofthese accessories may not a pply t oyour l awn mower.
LAWN MOWER PERFORMANCE
CLIPPING DEFLECTOR
FOR REAR DISCHARGE LAWN MOWERS
GRASS CATCHERS
FOR
REAR DISCHARGE
LAWN MOWERS
MULCHER KITS
GRASS CATCHERS
FOR
SIDE DISCHARGE
LAWN MOWERS
STABILIZER
GAS CANS
LAWN MOWER MAINTENANCE
MUFFLERS
BELTS BLADES
AIR FILTERS
BLADE ADAPTERS WHEELS
SPARK PLUGS
ENGINE OIL
Read these instructions and this manual in
its entirety before you attempt to assemble
or operate your new lawn mower. Your new
lawn mower has been assembled at the
factory with the exception of those parts left
unassembled for shipping purposes. All
parts such as nuts, washers, bolts, etc.,
necessary to complete the assembly have
been placed in the parts bag. To ensure
safe and proper operation of your lawn
mower, all parts and hardware you assem-
ble must be tightened securely. Use the
correct tools as necessary to ensure proper
tightness.
TO REMOVE LAWN MOWER FROM
CARTON
Remove loose parts included with mower.
o Cut down two end corners of carton and
lay end panel down flat.
• Remove all packing materials except
padding between upper and lower handle
and padding holding operator presence
control bar to upper handle.
= Roll lawn mower out of carton and check
carton thoroughly for additional loose
parts.
HOW TO SET UP YOUR LAWN
MOWER
TO UNFOLD HANDLE
IMPORTANT: Unfold handles carefully so
as not to pinch or damage control cables.
, Raise handles until lower handle section
locks into place in mowing position.
o Remove protective padding,- raise upper
handle section into place on lower handle
and tighten both handle knobs.
. Remove handle padding holding operator
presence control bar to upper handle.
* Your lawn mower handle can be adjusted
for your mowing comfort. Refer to "Adjust
4