Publicidad
Idiomas disponibles
Idiomas disponibles
Confirm your Accessories
¶ Speaker wire
¶ Acoustic control
material
¶ Hook-and-loop fastener strip
(hook) x 1
¶ Hook-and-loop fastener strip
(loop) x 1
¶ Operating Instructions
Regarding Installation
The playback sound from the speaker system may change
sensitively as a result of influences from the conditions of
the listening room. When installing the speakers,
consider the location carefully in order to get optimum
results from your installation.
¶ For a suspended installation, fasten a cord or chain to
the metal fixture on the rear panel and attach securely
to a pillar or wall. Be sure the pillar or wall used has
sufficient strength to support the speaker's weight.
After installing the speaker, confirm that it is
supported securely and will not fall.
¶ If the speaker falls it may be damaged.
¶ Do not hang the speaker directly from the metal fixture
on the rear panel. To prevent the speaker from falling,
always attach a cord or chain to the metal fixture when
suspending the speaker from a wall or pillar.
<Rear Panel of Speaker>
Mounting
fixture
Always attach a cord or chain to the
mounting fixture when using the
speaker in a suspended installation.
2
En
Cable or chain
Pioneer disclaims all responsibility for any losses or
damage resulting from improper assembly,
installation, insufficient strength of the installation
materials, misuse, or natural disasters.
¶ This speaker system weighs
about 8 kilograms. Floor installa-
tions should be on a flat and
stable floor surface; the speaker
should be installed away from
walls, as shown in the accompa-
nying illustration.
The distance between the speaker and the wall behind
it can be changed to adjust the bass emphasis. Adjust
the distance so that no audible difference in tone is
heard from left and right speakers.
¶ The most natural listening experience will be produced
when the listening position is midway between and an
equal distance from the two speakers, as shown.
Adjust the speaker wire to the same length from both
speakers.
7 Adjusting the Bass Range
This speaker system is supplied with acoustic control
material which can be affixed to the bottom of the stand
as a means of adjusting the bass frequency range.
Apply the material as shown, in accordance with your
installation location and personal listening tastes.
Acoustic control material
Apply acoustic control material sheet to the
bottom surface of the speaker system stand.
Take care not to allow the sheet to come
between the small skid-pads and floor.
50cm
20cm
Publicidad
